RepliWeb - Distributing Corporate Data to Multiple Sites, Using LANs, WANs, VPNs or the Internet

Configuring RDS

RepliWeb offers fully functional, fully licensed, non-intrusive software products.

RDS is a high level TCP/IP application that enables scheduled directory replication and synchronization of file systems over LANs, WANs, VPNs and the Internet.

RDS is extensively documented and supported (including pre-sales support)

RDS is available for a thirty-day evaluation period. The RepliWeb support team will be happy to assist you during this period.

RDS installs quickly...
	-	No modification of system files or kernels
	-	No reboot required (following install/uninstall)

To experience the modularity, flexibility, robustness, and functionality of RDS, simply install the respective components on the test systems (Note: It is strongly recommended that a test environment be used for initial evaluation):
	-	Since each stage is to run completely independently of the others, define a container on each node that will propagate the data further. Each container should contain an upload job to each of the respective target systems that content will be delivered to. Each job should be scheduled to run daily and the compression and bandwidth control options should be specified in the Performance tab of the job properties section for jobs operating over slow networks or where network response time not be affected (note that this may increase strain on the systems). For jobs that will run over the Internet or a VPN, increase the max number of concurrent transfers to three.
	-	To configure advanced security and encryption, contact support
	-	The e-mail notification (On exit>Exit procedure>E-mail) can be configured to notify the recipient as to the status of the replication.
	-	If the systems are separated by a firewall, ensure that the appropriate ports are configured to allow the replication to proceed.

TOP